Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral cable sub-assembly that indicates a power supply system problem.
DTC Code
DTC Detection Condition
Trouble Area
C1625
Open or short in steering angle sensor +B
Harness or connector
Spiral cable sub-assembly
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Since the parking assist monitor system has functions that use CAN communication system, first confirm that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.
When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BATTERY AND BODY GROUND)
Disconnect the G33 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
G33-2 (ESS) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
G33-5 (IG) - G33-2 (ESS)
Engine switch on (IG)
11 to 14 V
G33-6 (BAT) - G33-2 (ESS)
Always
11 to 14 V
Text in Illustration
*a
Front view of wire harness connector (to Spiral Cable Sub-assembly)