2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built from Aug 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.

HINT:
If CAN communication system DTCs are stored, they may also be stored for other systems.

DTC Code
DTC Detection Condition
Trouble Area
U0100
Lost communication with ECM
CAN communication system
U0126
Lost communication with spiral cable sub-assembly
U0129
Lost communication with skid control ECU
U0142
Lost communication with main body ECU (multiplex network body ECU)

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    OK (for LHD with Entry and Start System)
    A
    OK (for LHD without Entry and Start System)
    B
    OK (for RHD with Entry and Start System)
    C
    OK (for RHD without Entry and Start System)
    D
    NG
    E

HINT:
  1. If CAN communication system DTCs are stored, they may also be stored for other systems.
  2. If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.
  3. If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (Click here).



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (Click here)

E
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)


← U0100 Lost Communication with ECM / PCM "A" (+ U0126, U0129, U0142) (Aug 2013 – Jul 2014)U0232 Lost Communication with Blind Spot Monitor Slave Module (Aug 2013 – Jul 2014) →