REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1.
REMOVE INSTRUMENT SIDE PANEL LH
|
 |
Put protective tape around the instrument side panel.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 5 clips, claw and 3 guides and remove the instrument side panel.
| 2.
REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
|
 |
Put protective tape around the instrument panel ornament.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.
| 3.
REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
|
 |
Detach the 4 clips.
Disconnect each connector and remove the instrument panel finish plate garnish.
| 4.
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
|
 |
Detach the 4 clips.
Disconnect each connector and remove the instrument panel finish panel.
| 5.
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
|
 |
Detach the 4 claws, 2 clips and 2 guides and remove the instrument cluster finish panel.
| 6.
REMOVE LOWER STEERING COLUMN COVER
|
 |
- Remove the 2 screws.
Detach the 2 claws and remove the steering column lower cover.
| 7.
REMOVE UPPER STEERING COLUMN COVER
|
 |
- Detach the 4 clips.
Detach the claw and remove the steering column upper cover.
| 8.
REMOVE TRANSPONDER KEY AMPLIFIER |
 |
- Remove the screw and cover.
- Turn the key amplifier as shown in the illustration to detach the 2 claws and remove the key amplifier.
Disconnect the connector.