2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

  1. B238328
    Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the airbag assembly with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
  1. Connect each connector and each cable.

  1. w/o Knee Airbag:

    1. Attach the 7 clips to install the lower instrument panel finish panel.

  1. w/ Knee Airbag:

    1. Attach the 14 clips to install the lower instrument panel finish panel.

  1. Install the 2 bolts <C>.

  1. Attach the 2 claws to close the cover.


3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
  1. Connect each connector.

  1. Attach the 4 clips to install the instrument panel finish panel.


4. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
  1. Attach the 3 clips to install the instrument cluster finish panel ornament.


5. INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
  1. Connect each connector.

  1. Attach the 4 clips to install the instrument panel finish plate garnish.


6. INSTALL INSTRUMENT SIDE PANEL LH (for LHD)
  1. Attach the 5 clips, claw and 3 guides to install the instrument side panel.


7. INSTALL INSTRUMENT SIDE PANEL RH (for RHD)
  1. Connect the connector.

  1. Attach the 5 clips, claw and 3 guides to install the instrument side panel.


8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. for LHD:

    1. Attach the 2 clips and 2 guides to install the No. 1 instrument panel under cover.

    2. Install the screw.

  1. for RHD:

    1. Attach the 3 clips and 2 guides to install the No. 1 instrument panel under cover.

    2. Install the screw.


9. INSTALL COWL SIDE TRIM BOARD LH (for LHD)
  1. Attach the clip and claw to install the cowl side trim board.

  1. Install the clip.


10. INSTALL COWL SIDE TRIM BOARD RH (for RHD)

HINT:
Use the same procedure described for the LH side.


11. INSTALL DOOR SCUFF PLATE ASSEMBLY LH (for LHD)
  1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.


12. INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

HINT:
Use the same procedure described for the LH side.


13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


14. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).

← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →