HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the following procedure to troubleshoot the G-BOOK system.
- *: Use the GTS.
- Use the following procedure to troubleshoot the G-BOOK system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CHECK PROBLEM SYMPTOM |
The G-BOOK system provides a variety of functions. Therefore, it is important to identify whether a malfunction is related to the communication system, including radio wave conditions, or any other systems. Carefully confirm the conditions that caused the malfunction in order to determine if a temporary problem with the radio wave signal condition caused the malfunction.
Displayed Message and Problem Symptom
Cause
A message is displayed temporarily indicating to try again after moving the vehicle because the center cannot be accessed, as the screen cannot be displayed due to a busy line, etc.
This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is).
A message is displayed temporarily indicating to try again after waiting for a while because the information cannot be retrieved due to a busy line, etc.
This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is).
A message is displayed temporarily indicating to try again after waiting for a while because the lines are busy.
This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunctions and ask them to use the system as is).
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CHECK CAN COMMUNICATION SYSTEM* |
Use the GTS to check if the CAN communication system is functioning normally (Click here).
Result Result
Proceed to
CAN communication system DTC is not output.
A
CAN communication system DTC is output.
B
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in Problem Symptoms Table.
A
Fault is listed in Problem Symptoms Table.
B
- HINT:
- If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms (Click here).
|
|||||
| |||||
| 6.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM |
Refer to Terminals of ECU (Click here).
| |||||
| 7.CHECK CIRCUIT |
Adjust, repair or replace as necessary.
- NOTICE:
- If the navigation receiver assembly is replaced, perform the vehicle contract setting (Click here).
| |||||
| 8.PERFORM CONFIRMATION TEST |
| |||||