2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT OUTER MIRROR HEATER SWITCH ASSEMBLY

  1. B242863E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (IG) - 9 (E)
    Outer mirror heater switch on
    Below 1 Ω
    6 (IG) - 9 (E)
    Outer mirror heater switch off
    10 kΩ or higher

    If the result is not as specified, replace the outer mirror heater switch assembly.

  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 6 (IG)
    Battery negative (-) → 10 (D)
    Indicator LED illuminates
    Battery positive (+) → 8 (ILL+)
    Battery negative (-) → 7 (ILL-)
    Illumination LED illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Outer Mirror Heater Switch Assembly)

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →