B1585 USB Device Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1585 |
USB Device Malfunction
|
|
INSPECTION PROCEDURE
- HINT:
- When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
| 1. REPLACE USB DEVICE OR “iPod” |
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Turn the engine switch off.
- HINT:
- When this DTC has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the engine switch on (ACC).
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
- HINT:
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
- Refer to System Description for compatible formats and versions (Click here).
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
| NEXT | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
