2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2036 Power Supply Relay Malfunction Open

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored during the seat belt control ECU self-diagnosis or when power is not supplied to the seat belt control ECU.
DTC Code
DTC Detection Condition
Trouble Area
B2036
An open in the power supply circuit.
  1. Harness or connector
  2. Seat belt control ECU

WIRING DIAGRAM

E200775E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (SEAT BELT CONTROL ECU - BATTERY AND BODY GROUND)

  1. E186664E03
    Disconnect the G118 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G118-7 (+B) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G118-8 (PGND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Seat Belt Control ECU)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SEAT BELT CONTROL ECU (Click here)


← B2036 Power Supply Relay Malfunction Open (Aug 2013 – Jul 2014)B2060 ABS Malfunction (Aug 2013 – Jul 2014) →