2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2060 ABS Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when a malfunction in the brake system is detected. This circuit consists of the skid control ECU and seat belt control ECU. Signals are sent from the skid control ECU to the seat belt control ECU through the CAN communication line.
DTC Code
DTC Detection Condition
Trouble Area
B2060
While the initial check is running, the ignition switch is ON and the pre-crash safety system is operating, a brake system malfunction signal is received from the skid control ECU for 1 second.
  1. Vehicle stability control system
  2. Seat belt control ECU

INSPECTION PROCEDURE


1. CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    Vehicle stability control system DTCs are not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2060 is not output.



NG
REPLACE SEAT BELT CONTROL ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← B2060 ABS Malfunction (Aug 2013 – Jul 2014)B2064 Vehicle Type Signal Malfunction (Aug 2013 – Jul 2014) →