2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. When removing the stripe tape, heat the vehicle body and stripe tape using a heat light.

    Standard:
    Item
    Temperature
    Vehicle Body
    40 to 60°C (104 to 140°F)
    Stripe Tape
    20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or stripe tape excessively.


1. REMOVE FENDER STRIPE LH

B236250
  1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.


2. REMOVE FRONT SIDE PANEL STRIPE LH

B236252
  1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.


3. REMOVE QUARTER STRIPE REAR UPPER LH

B240685
  1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.


4. REMOVE QUARTER STRIPE LH

B240683
  1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →