ROAD TEST
Troubleshooting · Vehicles built from Aug 2013
| INSPECT SET SWITCH |
Turn the cruise control switch on.

Check that the CRUISE main indicator light in the combination meter assembly illuminates.
Drive the vehicle at a desired speed (between 40 km/h and 200 km/h [25 mph and 125 mph]).
Push the cruise control switch to -SET.

Check that the SET indicator light in the combination meter assembly illuminates.
After releasing the switch, check that the vehicle cruises at the desired speed.
| INSPECT "+" SWITCH |
Turn the cruise control switch on.

Drive the vehicle at a desired speed (between 40 km/h and 200 km/h [25 mph and 125 mph]).
Push the cruise control switch to -SET.

Check that the vehicle speed increases while the cruise control switch is pushed to +RES, and that the vehicle cruises at the set speed when the cruise control switch is released.

Momentarily push the cruise control switch upward to +RES and immediately release it. Check that the vehicle speed increases by about 1.6 km/h (1 mph) (tap-up function).
| INSPECT "-" SWITCH |
Turn the cruise control switch on.

Drive the vehicle at a desired speed (between 40 km/h and 200 km/h [25 mph and 125 mph]).
Push the cruise control switch to -SET.

Check that the vehicle speed decreases while the cruise control switch is pushed down to -SET, and that the vehicle cruises at the set speed when the cruise control switch is released.
Momentarily push the cruise control switch downward to -SET and immediately release it. Check that the vehicle speed decreases by about 1.6 km/h (1 mph) (tap-down function).
| INSPECT CANCEL FUNCTION (CANCEL SWITCH) |
Turn the cruise control switch on.

Drive the vehicle at a desired speed (between 40 km/h and 200 km/h [25 mph and 125 mph]).
Push the cruise control switch to -SET.

When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.
- Depressing the brake pedal
- Pushing the cruise control switch off
- Pulling the cruise control switch to CANCEL
- Driving the vehicle while the vehicle stability control system is operating
- for Automatic Transmission:
Moving the shift lever from D to N, or selecting 3rd, 2nd or 1st range with the shift lever in S
- for Manual Transmission:
Depressing the clutch pedal
- Depressing the brake pedal
| INSPECT RES (RESUME) SWITCH |
Turn the cruise control switch on.

Drive the vehicle at a desired speed (between 40 km/h and 200 km/h [25 mph and 125 mph]).
Push the cruise control switch to -SET.

Cancel the cruise control system by performing one of the following.
- Depressing the brake pedal
-
Pulling the cruise control switch to CANCEL

- Driving the vehicle while the vehicle stability control system is operating
- for Automatic Transmission:
Moving the shift lever from D to N, or selecting 3rd, 2nd or 1st range with the shift lever in S
- for Manual Transmission:
Depressing the clutch pedal
- Depressing the brake pedal
After the cruise control switch is pushed up to +RES at a driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed that was set before the cancellation.
