DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2013
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Cruise Control / Data List.
According to the display on the intelligent tester, read the Data List.
Cruise Control Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
CCS Vehicle Spd
Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph)
Actual vehicle speed displayed
-
CCS Mem Vehicle Spd
Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph)
Vehicle speed stored in memory
-
Throttle Opening Angle*1
Required throttle opening angle / Min.: 0°, Max.: 124.5°
Required throttle opening angle
-
Throttle Opening Angle*2
Required throttle opening amount / Min.: 0%, Max.: 100%
Required throttle opening amount
-
Cruise Control
Cruise control / ON or OFF
ON: Cruise control set
OFF: Cruise control not set
-
Main SW M-CPU
Cruise control switch (Main CPU) / ON or OFF
ON: Cruise control switch on
OFF: Cruise control switch off
-
CCS Ready M-CPU
Cruise control system standby condition (Main CPU) / ON or OFF
ON: Cruise control switch on
OFF: Cruise control switch off
-
CCS Indicator M-CPU
CRUISE main indicator (Main CPU) / ON or OFF
ON: CRUISE main indicator light on
OFF: CRUISE main indicator light off
-
Cancel Switch
CANCEL switch signal / ON or OFF
ON: CANCEL switch on
OFF: CANCEL switch off
-
SET/COAST Switch
-SET switch signal / ON or OFF
ON: -SET switch on
OFF: -SET switch off
-
RES/ACC Switch
+RES switch signal / ON or OFF
ON: +RES switch on
OFF: +RES switch off
-
Stp Light SW M-CPU
Stop light switch signal (Main CPU) / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Cruise Operation Status
Shift lever position signal / ON or OFF
ON: Shift lever in D
OFF: Shift lever not in D
-
- *1: for 1GR-FE, 2TR-FE
- *2: for 1KD-FTV
- *1: for 1GR-FE, 2TR-FE
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Combination Meter Tester Display
Test Part
Control Range
Diagnostic Note
Indicat. Lamp Cruise
Cruise control indicator light
ON/OFF
-
Indicat. SET
Cruise control SET indicator light
ON/OFF
-