2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

P0503 Vehicle Speed Sensor Circuit Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while cruise control is in operation, the ECM determines there to be a momentary interruption or noise and stores a DTC.
DTC Code
DTC Detection Condition
Trouble Area
P0503
A malfunction in the vehicle speed signal is detected while cruise control is in operation.
  1. Vehicle stability control system
  2. Vehicle speed sensor signal circuit
  3. Vehicle speed sensor
  4. Combination meter assembly
  5. ECM

INSPECTION PROCEDURE


1. CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    Vehicle stability control system DTCs are not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 40 km/h (25 mph) or more.

    2. Turn the cruise control switch on.

    3. Push the cruise control switch to -SET to activate cruise control.

  1. Check for DTCs (Click here).

    OK:
    DTC P0503 is not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1GR-FE)
    B
    NG (for 1KD-FTV [w/o DPF])
    C
    NG (for 1KD-FTV [w/ DPF])
    D



B
GO TO SFI SYSTEM (Click here)

C
GO TO ECD SYSTEM (Click here)

D
GO TO ECD SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← P0500 Vehicle Speed Sensor Malfunction (from Aug 2014)P0503 Vehicle Speed Sensor Circuit Malfunction (from Aug 2014) →