2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Back-up Light Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit sends the back-up light switch signals to the clearance warning ECU.

WIRING DIAGRAM

E202337E08

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
E179072
  1. Disconnect the C41 back-up light switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    1 - 2
    Released
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (for RA61F)
    B
    NG (for R150F)
    C
    NG (for G52F)
    D



B
REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)

C
REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)

D
REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)
A


2. CHECK HARNESS AND CONNECTOR (BACK-UP LIGHT SWITCH - BATTERY)

  1. E195965E03
    Disconnect the C41 back-up light switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    C41-2 - Body ground
    Ignition switch ON
    11 to 14 V
    C41-2 - Body ground
    Ignition switch off
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Back-up Light Switch Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BACK-UP LIGHT SWITCH)
  1. Disconnect the I1 clearance warning ECU connector.

  1. Disconnect the C41 back-up light switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I1-13 (RL) - C41-1 (RL)
    Always
    Below 1 Ω
    I1-13 (RL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Back-up Light Circuit (Aug 2013 – Jul 2014)Taillight Relay Circuit (Aug 2013 – Jul 2014) →