P1578 Brake System Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored when the vehicle stability control system has a problem. Check the vehicle stability control system when this DTC is output.| DTC Code |
DTC Detection Condition |
Trouble Area |
| P1578 |
While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, the ECM receives a vehicle stability control system malfunction signal for 1 second. |
|
INSPECTION PROCEDURE
- NOTICE:
- When the ECM is replaced with a new one, initialization must be performed (Click here).
| 1. CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM) |
Check for DTCs (Click here).
- OK:
- Vehicle stability control system DTCs are not output.
|
|
||||
| OK | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Perform the following to make sure the DTC detection conditions are met.
- HINT:
- If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 50 km/h (31 mph) or more.
Turn the cruise control switch on.
Check for DTCs (Click here).
- OK:
- DTC P1578 is not output.
Result Result
Proceed to
OK
A
NG (for 1GR-FE)
B
NG (for 1KD-FTV)
C
|
|
||||
|
|
||||
| A | ||
| ||
