Millimeter Wave Radar Sensor Power Source Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit provides power to the millimeter wave radar sensor. The millimeter wave radar sensor emits radar waves towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between the vehicle and the object in front.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR - BATTERY AND BODY GROUND) |
- NOTICE:
- A DTC is stored when the following inspection is performed. Be sure to clear the DTC after performing this inspection.
Disconnect the A15 sensor connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A15-5 (IGB) - Body ground
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A15-2 (SGND) - Body ground
Always
Below 1 Ω
| *a |
Front view of wire harness connector (to Millimeter Wave Radar Sensor Assembly) |
|
|
||||
| OK | ||
| ||
