2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE INTAKE PIPE

  1. A224305E01
    Loosen the hose clamp and remove the 2 bolts and intake pipe.


2. REMOVE INTAKE FLANGE

  1. A224307
    Remove the bolt and disconnect the PCV hose and heater hose bracket.

  1. A224306
    Disconnect the manifold absolute pressure sensor connector.

  1. A224831
    Remove the 3 nuts, intake flange and gasket.


3. REMOVE DIESEL THROTTLE BODY ASSEMBLY

  1. A224308
    Disconnect the throttle open switch connector.

  1. Remove the 2 bolts and disconnect the wire harness bracket.

  1. A111053E02
    Disconnect the throttle control motor connector.

  1. Remove the diesel throttle body and gasket.


4. REMOVE INJECTION PIPE

  1. A121940
    Using a 17 mm union nut wrench, loosen the 8 union nuts of the 4 injection pipes.

  1. Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes together with the 2 lower pipe clamps.


5. REMOVE INTAKE MANIFOLD

  1. A224309
    Remove the bolt and disconnect the wire harness bracket.

  1. A224310
    Remove the 6 bolts, 2 nuts, intake manifold and gasket.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →