2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts and disconnect the tailpipe from the exhaust pipe support.

  1. Remove the gasket and exhaust pipe support.


2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs, and then disconnect the center exhaust pipe from the 3 exhaust pipe supports.

  1. Remove the gasket.


3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 2 nuts and front exhaust pipe.

  1. Remove the gasket.


4. REMOVE EXHAUST PIPE STOPPER BRACKET
  1. Remove the 2 bolts and stopper bracket.


5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 2 nuts and front exhaust pipe.

  1. Remove the gasket.


6. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Disconnect the sensor connector.

  1. A223687E01
    Using SST, remove the sensor.
    SST
    09224-00010  


7. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

  1. A223689E01
    Using SST, remove the sensor.
    SST
    09224-00010  

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →