2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE NO. 2 FUEL TANK PROTECTOR

  1. A220841
    Remove the 5 bolts and No. 2 fuel tank protector.


3. DISCONNECT FUEL HOSE

  1. A220849
    Disconnect the fuel evaporation hose, fuel breather hose and 3 fuel hoses.


4. DISCONNECT FUEL TANK TO FILLER PIPE HOSE

  1. A220844
    Disconnect the fuel tank to filler pipe hose from the filler pipe.


5. DISCONNECT FUEL TANK BREATHER HOSE

  1. A223265
    Disconnect the fuel tank breather hose from the filler pipe.


6. REMOVE FUEL SUB TANK SUB-ASSEMBLY

  1. A220842
    Disconnect the fuel sender gauge connector.

  1. Set a transmission jack underneath the fuel sub tank.

  1. A220845
    Remove the 4 bolts and disconnect the 2 fuel tank bands.

  1. Remove the fuel sub tank.


7. REMOVE FUEL TANK VENT TUBE ASSEMBLY

  1. A220851
    Detach the wire harness clamp.

  1. Remove the 8 screws and fuel tank vent tube.

    NOTICE:
    Be careful not to bend the arm of the fuel sender gauge.

  1. Remove the gasket from the fuel tank vent tube.


8. REMOVE FUEL TANK TO FILLER PIPE HOSE

  1. A220847
    Remove the fuel tank to filler pipe hose from the fuel sub tank.


9. REMOVE FUEL TANK BREATHER HOSE

  1. A223266
    Remove the fuel tank breather hose from the fuel sub tank.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →