INSTALLATION
Removal / installation · Vehicles built from Aug 2013
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. INSTALL REAR NO. 2 SEAT ASSEMBLY LH |
Place the rear No. 2 seat assembly in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
- HINT:
- If installing the seat on the RH side with the LH side installed, install it with the rear seat leg cover LH raised.
Temporarily install the 4 bolts.
Tighten the 4 bolts.
- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Attach the 6 claws and 2 guides to close the 2 covers.

Text in Illustration *1
Guide
| 2. INSTALL NO. 1 DECK BOARD BRACKET LH |
Install the bracket with the 2 bolts.
| 3. INSTALL DECK BOARD BRACKET REINFORCEMENT |
Attach the 2 hooks to install the reinforcement.
Install the 2 bolts.
| 4. INSTALL REAR FLOOR MAT SUPPORT PLATE |
Attach the 5 clips and 2 guides.
Attach the 4 claws to install the plate.
Install the 3 bolts.
| 5. INSTALL REAR NO. 3 FLOOR BOARD (w/o Rear Air Conditioning System) |
Attach the 2 guides and 4 claws.

Text in Illustration *1
Guide
Attach the clip to install the board.
| 6. INSTALL REAR NO. 3 FLOOR BOARD (w/ Rear Air Conditioning System) |
Attach the 2 guides and 3 claws.

Text in Illustration *1
Guide
Attach the clip to install the board.
| 7. INSTALL REAR NO. 4 FLOOR BOARD |
Attach the 2 guides and 3 claws.

Text in Illustration *1
Guide
Attach the clip to install the board.
| 8. INSTALL DECK BOARD ASSEMBLY |
Attach the 4 clips to install the board.
Install the 2 bolts.
Attach the 2 claws to close the cover.

- HINT:
- Use the same procedure to close the cover on the other side.
