INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for LHD and RHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.
| 1.
INSTALL REAR DOOR INSIDE HANDLE ILLUMINATION LIGHT ASSEMBLY LH |
 |
- Connect the connector.
Attach the claw to install the light.
| 2.
INSTALL NO. 2 INTERIOR ILLUMINATION LIGHT SUB-ASSEMBLY |
 |
- Turn the light in the direction indicated by the arrow to install it.
Attach the clamp.
Connect the connector.
| 3.
INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
|
 |
- Attach the 3 claws to install the rear door inner glass weatherstrip as shown in the illustration.
| 4.
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
|
 |
- Install the clamp to the door panel.
Connect the rear door lock remote control cable assembly and rear door inside locking cable assembly.
Connect each connector.
- Attach the rear door trim board sub-assembly by attaching the 4 claws of the rear door inner glass weatherstrip as shown in the illustration.
Attach the 9 clips and install the rear door trim board sub-assembly.
Install the 3 screws.
| 5.
INSTALL FRONT DOOR ARMREST COVER LH
|
 |
- Attach the 8 claws to install the assist grip cover.
| 6.
INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
|
 |
- Attach the 3 claws to install the door inside handle bezel.