2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE FUEL TANK VENT TUBE ASSEMBLY (for 5 Door)
(Click here)

2. REMOVE REAR FLOOR MAT SUPPORT PLATE (for 3 Door)

B240526
  1. Remove the 5 screws.

  1. Detach the 6 claws and remove the rear floor mat rear support plate.


3. REMOVE REAR FLOOR SERVICE HOLE COVER (for 3 Door)

HINT:
Fold back the floor mat so that the rear floor service hole cover can be removed.

  1. A220855
    Remove the 3 screws and rear floor service hole cover.


4. REMOVE FUEL SENDER GAUGE ASSEMBLY (for 5 Door)

  1. A223143
    Disconnect the fuel sender gauge assembly connector.

  1. A329761E01
    Press down on the fuel sender gauge assembly claw labeled A. Then slide the fuel sender gauge assembly upward to remove it.
    Text in Illustration 
    V100135
    Press down
    V100136
    Slide


5. REMOVE FUEL SENDER GAUGE ASSEMBLY (for 3 Door)

  1. A223161
    Disconnect the fuel sender gauge assembly connector and fuel tank ground connector.

  1. Remove the 5 screws and fuel sender gauge assembly.

  1. Remove the gasket from the fuel sender gauge assembly.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (Aug 2013 – Jul 2014) →