2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REASSEMBLY

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


NOTICE:
A223126
Do not disconnect the hoses indicated in the illustration.


1. INSTALL FUEL PUMP

  1. A152630E02
    Install the fuel pump spacer and a new O-ring to the fuel pump.
    Text in Illustration 
    *1
    O-Ring
    *2
    Fuel Pump Spacer
    *3
    Fuel Pump

  1. Apply a light coat of diesel fuel to the O-ring of the fuel pump.

  1. Push in the fuel pump to the fuel suction plate.


2. CONNECT JET PUMP

  1. A152629
    Set the jet pump into the No. 1 fuel sub-tank. Then slide the jet pump downward to install it.

    HINT:
    Make sure that the jet pump is attached at the 2 positions as shown in the illustration.


3. INSTALL FUEL PUMP HARNESS
  1. Connect the fuel pump harness connector to the fuel suction plate.

  1. Connect the fuel pump harness connector to the fuel pump.


4. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY

  1. A224451
    Attach the 3 claws to the claw holes to install the fuel suction plate.


5. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A329767E01
    Set the fuel sender gauge assembly on the fuel sub-tank. Then slide the fuel sender gauge assembly downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-Tank
    V100135
    Slide

  1. Connect the fuel sender gauge assembly connector.

← REASSEMBLY (Aug 2013 – Jul 2014)INSTALLATION (Aug 2013 – Jul 2014) →