2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL FUEL SENDER GAUGE ASSEMBLY (for Fuel Main Tank)

  1. A331220E01
    Set the fuel sender gauge assembly on the fuel sub-tank. Then slide the fuel sender gauge assembly downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-tank
    V100135
    Slide

  1. Connect the fuel sender gauge connector.


2. INSTALL FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank)

  1. A334482E01
    Set the fuel sender gauge assembly on the fuel gauge support. Then slide the fuel sender gauge assembly upward to install it.
    Text in Illustration 
    *1
    Fuel Gauge Support
    V100135
    Slide

    NOTICE:
    Make sure the part labeled A in the illustration is securely inserted into the hole of the fuel gauge support before sliding the fuel sender gauge assembly upward.

  1. A334483E01
    Install the 2 lead wires with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

    Text in Illustration 
    *1
    Lead Wire (Black)
    *2
    Lead Wire (Red)

    NOTICE:
    Be sure to install the lead wires in the correct locations according to their color as shown in the illustration.


3. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (for Fuel Main Tank)
  1. Install the fuel suction with pump and gauge tube assembly (Click here).


4. INSTALL FUEL TANK VENT TUBE ASSEMBLY (for Fuel Sub Tank)
  1. Install the fuel tank vent tube assembly (Click here).

← INSTALLATION (Aug 2013 – Jul 2014)PRECAUTION (from Aug 2013) →