2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL FUEL SENDER GAUGE ASSEMBLY (for 5 Door)

  1. A228318E01
    Set the fuel sender gauge on the fuel sub-tank. Then slide the fuel sender gauge downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-Tank
    V100135
    Slide

  1. Connect the fuel sender gauge connector.


2. INSTALL FUEL SENDER GAUGE ASSEMBLY (for 3 Door)
  1. Install a new gasket and fuel sender gauge with the 5 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Connect the fuel sender gauge connector and fuel pump connector.


3. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (for 5 Door)
  1. Install the fuel suction with pump and gauge tube assembly (Click here).


4. INSTALL REAR FLOOR SERVICE HOLE COVER (for 3 Door)
  1. Install the rear floor service hole cover with the 3 screws.


5. INSTALL REAR FLOOR MAT SUPPORT PLATE (for 3 Door)
  1. Attach the 6 claws to install the rear floor mat rear support plate.

  1. Install the 5 screws.

← INSPECTION (from Aug 2014)INSTALLATION (from Aug 2014) →