2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Apply a light coat of gasoline or grease to a new gasket and install the gasket to the fuel tank.

  1. A220825E01
    Align the protrusion of the fuel suction with pump and gauge tube with the groove of the fuel tank.
    Text in Illustration 
    *1
    Protrusion
    *2
    Groove

    NOTICE:
    Be careful not to bend the arm of the fuel sender gauge.

  1. Install the fuel suction with pump and gauge tube to the fuel tank.

  1. Put a new retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer one complete turn by hand.

    Text in Illustration 
    *1
    Start Mark (Fuel Tank Side)
    *2
    Start Mark (Retainer Side)

    HINT:
    A220826E01
    Make sure the start marks on the retainer and fuel tank are aligned and then tighten the retainer.

  1. A243483E01
    Set SST on the retainer.
    SST
    09808-14030  

    HINT:
    1. Hold the fuel suction tube assembly upright by hand to ensure that the fuel suction tube gasket in not moved out of position.
    2. Engage the claws of SST securely with the fuel pump gauge retainer holes to secure SST.
    3. Install SST while pressing the claws of SST against the fuel pump gauge retainer (toward the center of SST).

  1. A243481E01
    Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank as shown in the illustration.
    SST
    09808-14030  
    Text in Illustration 
    *1
    Fuel Tank Side Mark
    *2
    Retainer Side Mark

    HINT:
    Fit the tips of SST onto the ribs of the retainer.


2. INSTALL FUEL TANK SUB-ASSEMBLY
  1. Install the fuel tank sub-assembly (Click here).

← INSTALLATION (Aug 2013 – Jul 2014)COMPONENTS (from Aug 2013) →