C1882/82 Power Supply Voltage Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The stabilizer control ECU recognizes the ignition switch ON signal based on the voltage input to the IG terminal.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1882/82 |
The IG terminal voltage is 10 V or less or 16 V or higher for 0.5 seconds |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. READ VALUE USING INTELLIGENT TESTER (IG POWER SOURCE VOLTAGE) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / KDSS / Data List.
Select the item below in the Data List, and read the value displayed on the intelligent tester.
KDSS Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
IG Power Source Voltage
IG Power Source Voltage/
Min.: 0.0 V
Max.: 25.5 V
Ignition switch ON: 11 to 14 V
-
- Standard voltage:
- 11 to 14 V
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (IG TERMINAL) |
Disconnect the Stabilizer control ECU connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
G123-24 (IG) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Stabilizer Control ECU)
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (GND TERMINAL) |
Disconnect the Stabilizer control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G123-22 (GND) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
