2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


NOTICE:
Do not disconnect the hoses indicated in the illustration.
A228300E01
Text in Illustration 
*A
for Single Tank Type
*B
for Double Tank Type


1. INSTALL FUEL SUCTION CAP

  1. A228314E01
    Apply a light coat of gasoline to a new O-ring and install the O-ring to the fuel suction cap.
    Text in Illustration 
    *1
    New O-Ring

  1. Install the fuel suction cap to the fuel filter case.

    NOTICE:
    Make sure the O-ring is not cut or pinched during installation.


2. INSTALL FUEL PUMP
  1. Connect the fuel pump wire harness connector to the fuel pump.

  1. A223260E01
    Apply a light coat of gasoline to a new O-ring. Then install the fuel pump spacer and O-ring to the fuel pump.
    Text in Illustration 
    *1
    New O-Ring
    *2
    Fuel Pump Spacer

  1. A223259E01
    Attach the 5 claws to the claw holes to install the fuel pump to the fuel filter case.
    Text in Illustration 
    *1
    Fuel Filter Case

  1. A228312E01
    Attach the fuel pump wire harness clamp.
    Text in Illustration 
    *A
    for Single Tank Type
    *B
    for Double Tank Type


3. INSTALL NO. 1 FUEL SUB-TANK (for Single Tank Type)

  1. A228309
    Attach the 3 claws to the claw holes to install the No. 1 fuel sub-tank.

  1. A228307
    Attach the 3 claws to the claw holes.

  1. Install the tube part to the No. 1 fuel sub-tank.

    1. A228334E01
      Attach the claw on the end of the tube to the claw hole. Install the tube to the 2 clamps on the No. 1 fuel sub-tank.

  1. Connect the jet pump to the No. 1 fuel sub-tank.

    Text in Illustration 
    *1
    Jet Pump

  1. Connect the fuel pump connector.


4. INSTALL NO. 1 FUEL SUB-TANK (for Double Tank Type)

  1. A228310
    Attach the 3 claws to the claw holes to install the No. 1 fuel sub-tank.

  1. A228308
    Attach the 3 claws to the claw holes.

  1. Connect the jet pump labeled B to the No. 1 fuel sub-tank.

    1. A228305E01
      Attach the claw on the end of the tube to the claw hole.
      Text in Illustration 
      *1
      Jet Pump A
      *2
      Jet Pump B

  1. Connect the jet pump labeled A to the No. 1 fuel sub-tank.

  1. Connect the fuel pump connector.


5. INSTALL FUEL SENDER GAUGE ASSEMBLY (for Single Tank Type)

  1. A228318E01
    Set the fuel sender gauge on the fuel sub-tank. Then slide the fuel sender gauge downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-Tank
    V100135
    Slide

  1. Connect the fuel sender gauge connector.


6. INSTALL FUEL SENDER GAUGE ASSEMBLY (for Double Tank Type)

  1. A228322E01
    Set the fuel sender gauge on the fuel sub-tank. Then slide the fuel sender gauge downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-tank
    V100135
    Slide

  1. Connect the fuel sender gauge connector.

← INSPECTION (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →