2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REASSEMBLY

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


NOTICE:
A223124
Do not disconnect the hoses indicated in the illustration.


1. INSTALL FUEL MAIN VALVE ASSEMBLY

  1. A223172E01
    Apply a light coat of gasoline to 2 new O-rings and install the O-ring to the fuel main valve.
    Text in Illustration 
    *1
    New O-Ring

  1. Install the fuel main valve to the fuel filter case.

    NOTICE:
    Make sure the O-rings are not cut or pinched during installation.


2. INSTALL FUEL PUMP
  1. Connect the fuel pump wire harness connector to the fuel pump.

  1. A223260E01
    Apply a light coat of gasoline to a new O-ring. Then install the fuel pump spacer and O-ring to the fuel pump.
    Text in Illustration 
    *1
    New O-Ring
    *2
    Fuel Pump Spacer

  1. A223259E01
    Attach the 5 claws to the claw holes to install the fuel pump to the fuel filter case.
    Text in Illustration 
    *1
    Fuel Filter Case


3. INSTALL NO. 1 FUEL SUB-TANK

  1. A175041
    Attach the 3 claws to the claw holes to install the No. 1 fuel sub-tank.

  1. A223176
    Attach the 3 claws to the claw holes.

  1. Connect the jet pump labeled B to the No. 1 fuel sub-tank.

    1. A223177E01
      Attach the claw on the end of the tube to the claw hole.
      Text in Illustration 
      *1
      Jet Pump A
      *2
      Jet Pump B

  1. Connect the jet pump labeled A to the No. 1 fuel sub-tank.

  1. Connect the fuel pump connector.


4. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A223136E01
    Set the fuel sender gauge on the fuel sub-tank. Then slide the fuel sender gauge downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-tank
    V100135
    Slide

  1. Connect the fuel sender gauge connector.

← INSPECTION (from Aug 2013)REASSEMBLY (from Aug 2014) →