INSTALLATION
Removal / installation · Vehicles built from Aug 2013
| 1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY |
Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
- NOTICE:
- Do not apply adhesive to the oil inlet port of the oil pressure sender gauge.
Using a 27 mm deep socket wrench, install the oil pressure sender gauge.
- Torque:
- 15 N*m{ 153 kgf*cm , 11 ft.*lbf }
- NOTICE:
- Do not start the engine for at least 1 hour after installation.
Connect the engine oil pressure sender gauge connector.
| 2. ADD ENGINE OIL |
| 3. INSPECT FOR OIL LEAK |
Start the engine. Make sure that there are no oil leaks from the areas that were worked on.
