2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

E200370E01
  1. Put protective tape around the door scuff plate assembly RH.

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate assembly RH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


4. REMOVE COWL SIDE TRIM BOARD RH

E200371
  1. Remove the clip.

  1. Detach the clip and claw and remove the cowl side trim board RH.


5. REMOVE INSTRUMENT SIDE PANEL RH

B238212E01
  1. Put protective tape around the instrument side panel.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 clips, claw, and 3 guides.

  1. Disconnect the connector and remove the instrument side panel.


6. REMOVE INSTRUMENT PANEL ORNAMENT

B238217E01
  1. Put protective tape around the instrument panel ornament.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.


7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Remove the screw.

  1. Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.

    B298555E01

    Text in Illustration 
    *A
    for LHD
    *B
    for RHD


8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

B238219E01
  1. Remove the 2 bolts <C> and 2 screws <A> or <B>.

    Text in Illustration 
    *1
    Bolt
    *2
    Screw

  1. Detach the 5 clips and claw.

  1. Disconnect each connector and remove the glove compartment door.


9. REMOVE PARKING ASSIST ECU

B356820
  1. Disconnect each connector.

  1. Remove the 2 bolts and parking assist ECU.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →