2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).


2. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

B238105E01
  1. Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the handle.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE VERTICAL ADJUSTING HANDLE LH

B238107
  1. Remove the screw and handle.


4. REMOVE FRONT SEAT CUSHION SHIELD LH

  1. B238108
    Remove the screw.

  1. Using a moulding remover, detach the 4 claws and clip, and then remove the cushion shield.

  1. B239165
    for Driver Side:
    Detach the 5 wire harness clamps and disconnect the 2 connectors.


5. REMOVE LUMBAR SWITCH ASSEMBLY

B239166
  1. Remove the 2 screws and switch.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →