2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013

CAUTION:
  1. Wear protective gloves when removing the exhaust pipe.
  2. The exhaust pipe is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe has cooled down before removing it.


1. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts.

  1. Disconnect the exhaust pipe support to remove the tailpipe assembly.

  1. Remove the gasket.


2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts.

  1. Disconnect the 2 exhaust pipe supports to remove the center exhaust pipe assembly.

  1. Remove the gasket.


3. REMOVE AIR FUEL RATIO SENSOR

A223986
  1. Disconnect the air fuel ratio sensor connector.

  1. Detach the wire harness clamp.

  1. A223987E01
    Using SST, remove the air fuel ratio sensor.
    SST
    09224-00010  


4. REMOVE HEATED OXYGEN SENSOR

A223922
  1. Disconnect the heated oxygen sensor connector.

  1. Detach the wire harness clamp.

  1. A223923E01
    Using SST, remove the heated oxygen sensor.
    SST
    09224-00010  


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolt and 2 compression springs.

  1. Disconnect the exhaust pipe support to remove the front exhaust pipe assembly.

  1. Remove the gasket.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →