2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT VOLTAGE INVERTER ASSEMBLY

HINT:
Remove interior parts so that the voltage inverter can be seen.

  1. B239897E01
    Disconnect the voltage inverter connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Q17-5 (IG) - Q17-1 (GND)
    Ignition switch ON
    11 to 14 V
    Q17-1 (GND) - Body ground
    Always
    Below 1 V

    If the result is not as specified, repair or replace the harness or connector.
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Voltage Inverter Assembly)

  1. B239898E01
    Reconnect the voltage inverter connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Q17-4 (AC1) - Q17-8 (AC2)
    Ignition switch ON, main switch on
    AC 220 V

    If the result is not as specified, replace the voltage inverter assembly.
    Text in Illustration 
    *a
    Component with harness connected
    (Voltage Inverter Assembly)

← COMPONENTS (from Aug 2013)REMOVAL (Aug 2013 – Jul 2014) →