2013-2015 Land Cruiser Prado · Service Manual Suspension

ON-VEHICLE INSPECTION

Inspection · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


INSPECT INDICATOR LIGHT
  1. Check that the KDSS indicator light comes on for 2 seconds.
    If the indicator check result is not normal, proceed to troubleshooting for the Problem Symptoms Table (Click here).


INSPECT FLUID PRESSURE

NOTICE:
  1. Perform the inspection on a level surface.
  2. Make sure that the wheels are on the ground and facing straight ahead.
  3. Perform the inspection with the vehicle load completely on the suspension.

HINT:
  1. Perform this step with the fuel tank full.
  2. If there are any parts installed to the vehicle which place any unbalanced load on the left or right side of the vehicle, remove them.

  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / KDSS / Data List.

  1. Select the item below in the Data List, and read its value displayed on the intelligent tester.

    KDSS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Oil Pressure Sensor
    Oil pressure sensor/
    Min.: -784.79 MPa (-8002.66 kgf/cm2, -113794.55 psi)
    Max.: 784.76 MPa (8002.35 kgf/cm2, 113790.20 psi)
    2.6 MPa (26.5 kgf/cm2, 377 psi) to 3.0 MPa (30.6 kgf/cm2, 435 psi): When vehicle stopped and fluid temperature 20°C (68°F)
    -

    HINT:
    If the value is outside the specified range, there may be fluid leaks, clogs in the hydraulic circuit, or a lack or excess of fluid.

← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2014)ON-VEHICLE INSPECTION (from Aug 2014) →