DISASSEMBLY
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE NO. 1 ROOF SILENCER PAD |
![]() ![]() |
w/o Sliding Roof:
Remove the 3 No. 1 roof silencer pads.
w/ Sliding Roof:

Remove the No. 1 roof silencer pad.
| 2. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof) |
![]() ![]() |
Remove the No. 2 roof silencer pad.
| 3. REMOVE NO. 4 ROOF SILENCER PAD (w/o Sliding Roof) |
![]() ![]() |
Remove the No. 4 roof silencer pad.
| 4. REMOVE VANITY LIGHT ASSEMBLY LH |
![]() ![]() |
Detach the 2 claws labeled A and separate the bulb holder from the vanity light as shown in the illustration.
Detach the claw labeled B and remove the vanity light.
Text in Illustration *1
Claw A
*2
Claw B
*3
Bulb Holder
| 5. REMOVE VANITY LIGHT ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 6. REMOVE NO. 1 ROOF WIRE |
Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.
Detach each clamp and remove the No. 1 roof wire.
Remove any butyl tape remaining on the roof headlining.


Text in Illustration *A
w/o Sliding Roof
*B
w/ Sliding Roof
*C
w/ Rain Sensor, for LHD
*D
w/ EC Mirror
*E
w/ Rain Sensor, for RHD
-
-
*1
Visor Connector
-
-
| 7. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
w/o Sliding Roof:


Text in Illustration *A
for Diversity
*B
for Diversity, w/ Digital Audio Broadcasting
Detach the No. 2 antenna cord sub-assembly from the clamp and the notch on the rear of the roof headlining assembly.
for Diversity:
Detach the No. 2 antenna cord sub-assembly from the 6 clamps and the 2 notches on the rear of the roof headlining assembly.for Diversity, w/ Digital Audio Broadcasting:
Detach the No. 2 antenna cord sub-assembly from the 7 clamps and the 2 notches on the rear of the roof headlining assembly.Remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.
Remove the double-sided tape from the roof headlining assembly.
w/ Sliding Roof:


Text in Illustration *A
for Diversity
*B
for Diversity, w/ Digital Audio Broadcasting
Detach the No. 2 antenna cord sub-assembly from the 4 clamps and the notch on the rear of the roof headlining assembly.
for Diversity:
Detach the No. 2 antenna cord sub-assembly from the 9 clamps and the 2 notches on the rear of the roof headlining assembly.for Diversity, w/ Digital Audio Broadcasting:
Detach the No. 2 antenna cord sub-assembly from the 10 clamps and the 2 notches on the rear of the roof headlining assembly.Remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.
Remove the double-sided tape from the roof headlining assembly.




