2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

P144C Open in Secondary Air Injection System Heater Control Circuit

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The ECM operates the air pump heater relay which causes the air pump heater to operate.
DTC No.
DTC Detection Condition
Trouble Area
P144C
Open or short in the air pump heater relay circuit for 5 seconds (1 trip detection logic).
  1. Open or short in air pump heater relay circuit
  2. Air pump heater relay
  3. ECM
P144D
Open or short in the air pump heater relay circuit for 5 seconds (1 trip detection logic).
  1. Open or short in air pump heater relay circuit
  2. Air pump heater relay
  3. ECM

WIRING DIAGRAM

Refer to DTC P0412 (Click here).

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses of circuits related to this system before performing the following inspection procedure.

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. INSPECT AIR PUMP HEATER RELAY
  1. Inspect the air pump heater relay (Click here).



NG
REPLACE AIR PUMP HEATER RELAY
OK


2. CHECK AIR PUMP HEATER RELAY (POWER SOURCE)
  1. Remove the air pump heater relay.

  1. A227733E01
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Air pump heater relay terminal 2 - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *1
    Engine Room Relay Block
    *2
    Air Pump Heater Relay

  1. Reinstall the air pump heater relay.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (ECM - AIR PUMP HEATER RELAY)
  1. Remove the air pump heater relay.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Condition
    Specified Condition
    Air pump heater relay terminal 1 - C36-20 (HAI1)
    Always
    Below 1 Ω

    Standard Resistance (Check for Short):
    Tester Connection
    Condition
    Specified Condition
    Air pump heater relay terminal 1 or C36-20 (HAI1) - Body ground
    Always
    10 kΩ or higher

  1. Reinstall the air pump heater relay.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P0724 Brake Switch "B" Circuit High (from Aug 2014)P144C Open in Secondary Air Injection System Heater Control Circuit (+ P144D) (from Aug 2014) →