REPLACEMENT
Removal / installation · Vehicles built from Aug 2013
| 1.
DRAIN MANUAL TRANSMISSION OIL |
 |
- Remove the drain plug and gasket and then drain the manual transmission oil.
- Remove the filler plug and gasket.
Install a new gasket and the drain plug.
-
Torque:
- 37 N*m{
377 kgf*cm
, 27 ft.*lbf
}
| 2.
ADD MANUAL TRANSMISSION OIL |
|
| 3.
INSPECT MANUAL TRANSMISSION OIL |
 |
Stop the vehicle on a level surface.
- Check that the oil level is between 0 and 5 mm (0 and 0.196 in.) from the bottom lip of the filler plug opening.
- NOTICE:
- Problems may occur when the oil level is too high or low.
- After replacing the oil, drive the vehicle and check the oil level again.
Inspect for oil leaks when the oil level is low.
- Install a new gasket and the filler plug.
-
Torque:
- 37 N*m{
377 kgf*cm
, 27 ft.*lbf
}