2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the oil pressure switch connector.

  1. Start the engine.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Engine stopped
    Below 1 Ω
    Engine idling
    10 kΩ or higher

    If the result is not as specified, replace the oil pressure switch assembly.

  1. Connect the oil pressure switch connector.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →