2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY

  1. A224304
    Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.

  1. A226728
    Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.


2. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
  1. Remove the dipstick.

  1. A225177
    Remove the 2 bolts and dipstick guide.

  1. Remove the O-ring from the dipstick guide.


3. REMOVE VACUUM PUMP OIL INLET HOSE

  1. A118121
    Remove the union bolt and gasket, and then disconnect the vacuum pump oil inlet hose from the cylinder block.


4. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY

  1. A229802
    Using a 24 mm deep socket wrench, remove the oil pressure switch.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →