INSTALLATION
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER |
![]() ![]() |
- HINT:
- Use the same procedure to install the No. 1 ultrasonic sensor retainer on the other side.
Align the keyhole and protrusion as shown in the illustration.
Install the No. 1 ultrasonic sensor retainer to the front bumper cover.
- NOTICE:
- Do not damage the bumper cover with the protrusion when installing the retainer.
Text in Illustration *1
Keyhole
| 2. INSTALL NO. 1 ULTRASONIC SENSOR |
- HINT:
- Use the same procedure to install the No. 1 ultrasonic sensor on the other side.
Attach the 2 claws to install the No. 1 ultrasonic sensor.
Connect the connector.
| 3. INSTALL FRONT BUMPER COVER |
w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
Connect the 3 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
Connect the connector.
w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
Connect the 2 connectors.
w/ Headlight Cleaner System:
Connect the No. 1 headlight cleaner hose.
Attach the 16 claws to install the front bumper cover.
- NOTICE:
- Do not hold the middle of the front bumper cover, as it may become reformed.
Install the 4 clips.
Install the 2 bolts labeled A and 2 bolts labeled B.

- Torque:
- bolt B:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Text in Illustration *1
Screw
*2
Bolt A
*3
Bolt B
Install the 2 screws.
Install the 2 screws.
- HINT:
- Use the same procedure for the screws on the other side.
| 4. INSTALL RADIATOR GRILLE |
Attach the 8 claws to install the radiator grille.
Install the 4 screws.
| 5. INSTALL UPPER RADIATOR SUPPORT SEAL |
Install the upper radiator support seal with the 13 clips.

