2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL INPUT SHAFT FRONT BEARING

  1. D029020E01
    Using SST and a press, install a new front bearing.
    SST
    09950-60010   (09951-00400)
    09950-70010   (09951-07100)

  1. D033850E01
    Select a snap ring that will allow minimal axial play.

    Standard clearance:
    0.10 mm (0.0039 in.) or less

    Standard Front Bearing Shaft Snap Ring:
    Mark
    Thickness
    0
    2.05 to 2.10 mm (0.0807 to 0.0827 in.)
    1
    2.10 to 2.15 mm (0.0827 to 0.0847 in.)
    2
    2.15 to 2.20 mm (0.0847 to 0.0866 in.)
    3
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    4
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    5
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)

  1. D033851E01
    Using a snap ring expander, install the snap ring.


2. INSTALL INPUT SHAFT BEARING

  1. C086536E01
    Coat the 13 input shaft bearings with MP grease and install them to the input shaft.


3. INSTALL NO. 2 SYNCHRONIZER RING

  1. C067214E01
    Coat the No. 2 synchronizer ring with gear oil and install it to the input shaft.

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →