INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT IGNITION SWITCH ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
All combinations of all terminals
LOCK
10 kΩ or higher
2 (AM1) - 3 (ACC)
ACC
Below 1 Ω
2 (AM1) - 3 (ACC)
2 (AM1) - 4 (IG1)
6 (IG2) - 7 (AM2)
ON
Below 1 Ω
1 (ST1) - 2 (AM1)
1 (ST1) - 4 (IG1)
6 (IG2) - 7 (AM2)
6 (IG2) - 8 (ST2)
START
Below 1 Ω
If the result is not as specified, replace the ignition switch assembly.Text in Illustration *a
Component without harness connected
(Ignition Switch)
