2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REPLACEMENT

Removal / installation · Vehicles built from Aug 2013


1. DRAIN MANUAL TRANSMISSION OIL

  1. D029129E01
    Remove the drain plug and gasket, and then drain the manual transmission oil.

  1. D029128E01
    Remove the filler plug and gasket.

  1. Install a new gasket and the drain plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


2. ADD MANUAL TRANSMISSION OIL

3. INSPECT MANUAL TRANSMISSION OIL
  1. Stop the vehicle on a level surface.

  1. D025304E07
    Check that the oil level is between 0 and 5 mm (0 and 0.196 in.) from the bottom lip of the filler plug opening.

    NOTICE:
    1. Problems may occur when the oil level is too high or low.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. Inspect for oil leaks when the oil level is low.

  1. D029128E01
    Install a new gasket and the filler plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

← COMPONENTS (from Aug 2013)COMPONENTS (from Aug 2013) →