2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


4. REMOVE COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure described for the LH side.


5. REMOVE INSTRUMENT SIDE PANEL RH

B238212E01
  1. Put protective tape around the instrument side panel.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 clips, claw, and 3 guides.

  1. Disconnect the connector and remove the instrument side panel.


6. REMOVE INSTRUMENT PANEL ORNAMENT

B238217E01
  1. Put protective tape around the instrument panel ornament.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.


7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Remove the screw.

  1. Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.

    B298555E01

    Text in Illustration 
    *A
    for LHD
    *B
    for RHD


8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

B238219E01
  1. Remove the 2 bolts <C> and 2 screws <A> or <B>.

    Text in Illustration 
    *1
    Bolt
    *2
    Screw

  1. Detach the 5 clips and claw.

  1. Disconnect each connector and remove the glove compartment door.


9. REMOVE 4 WHEEL DRIVE CONTROL ECU

C216298
  1. Disconnect the 2 connectors.

  1. Remove the bolt and 4 wheel drive control ECU.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →