2013-2015 Land Cruiser Prado · Service Manual Brake

ON-VEHICLE INSPECTION

Inspection · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


INSPECT BRAKE PEDAL LOAD SENSING SWITCH

HINT:
  1. Do not remove the brake pedal load sensing switch from the brake pedal lever sub-assembly.
  2. When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal lever sub-assembly.
  3. The illustration below is for LHD vehicles. Check the brake pedal load sensing switch for RHD vehicles using the same procedure as for LHD vehicles.

  1. Disconnect the brake pedal load sensing switch connector.

    C217151E01

    Text in Illustration 
    *1
    Brake Pedal Load Sensing Switch
    *2
    Brake Pedal Support Assembly
    *a
    Brake Pedal Released (ON)
    *b
    Brake Pedal Depressed (OFF)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (FSW+) - 1(FSW-)
    Brake pedal depressed
    0.9 to 1.1 kΩ
    Brake pedal released
    192 to 234 Ω

    If the result is not as specified, replace the brake pedal support assembly (Click here).

← COMPONENTS (from Aug 2013)ON-VEHICLE INSPECTION (from Aug 2014) →