2013-2015 Land Cruiser Prado · Service Manual General

SERVICE DATA

Specifications · Vehicles built from Aug 2013

Rear Wiper Switch (w/ Rain Sensor, for LHD Windshield Wiper Switch and RHD) 
Resistance
12 (C1R) - 1 (EW)
Off
10 kΩ or higher
10 (+1R) - 1 (EW)
12 (C1R) - 1 (EW)
INT
Below 1 Ω
10 (+1R) - 1 (EW)
HI
Below 1 Ω
Rear Washer Switch (w/ Rain Sensor, for LHD Windshield Wiper Switch and RHD) 
Resistance
11 (WR) - 1 (EW)
Off
10 kΩ or higher
10 (+1R) - 1 (EW)
11 (WR) - 1 (EW)
WASH
Below 1 Ω
11 (WR) - 1 (EW)
On + WASH
Below 1 Ω
10 (+1R) - 1 (EW)
Front Wiper Switch (w/o Rain Sensor, for LHD Windshield Wiper Switch and RHD) 
Resistance
A-1 (+S) - A-3 (+1)
Off
Below 1 Ω
INT
A-2 (+B) - A-3 (+1)
MIST
LO
A-2 (+B) - A-4 (+2)
HI
Front Washer Switch (w/o Rain Sensor, for LHD Windshield Wiper Switch and RHD) 
Resistance
B-2 (EW) - B-3 (WF)
On
Below 1 Ω
Off
10 kΩ or higher
Rear Wiper Switch (w/o Rain Sensor, for LHD Windshield Wiper Switch and RHD) 
Resistance
B-6 (C1R) - B-2 (EW)
Off
10 kΩ or higher
B-7 (+1R) - B-2 (EW)
B-6 (C1R) - B-2 (EW)
INT
Below 1 Ω
B-7 (+1R) - B-2 (EW)
HI
Below 1 Ω
Rear Washer Switch (w/o Rain Sensor, for LHD Windshield Wiper Switch and RHD) 
Resistance
A-5 (WR) - B-2 (EW)
Off
10 kΩ or higher
B-7 (+1R) - B-2 (EW)
A-5 (WR) - B-2 (EW)
WASH
Below 1 Ω
A-5 (WR) - B-2 (EW)
On + WASH
Below 1 Ω
B-7 (+1R) - B-2 (EW)
Front Wiper Switch (w/o Rain Sensor, for RHD Windshield Wiper Switch LH Side Type) 
Resistance
A-4 (+S) - A-2 (+1)
Off
Below 1 Ω
INT
A-3 (+B) - A-2 (+1)
MIST
LO
A-3 (+B) - A-1 (+2)
HI
Front Washer Switch (w/o Rain Sensor, for RHD Windshield Wiper Switch LH Side Type) 
Resistance
B-2 (EW) - B-1 (WF)
On
Below 1 Ω
Off
10 kΩ or higher
Rear Wiper Switch (w/o Rain Sensor, for RHD Windshield Wiper Switch LH Side Type) 
Resistance
B-5 (C1R) - B-2 (EW)
Off
10 kΩ or higher
B-4 (+1R) - B-2 (EW)
B-5 (C1R) - B-2 (EW)
INT
Below 1 Ω
B-4 (+1R) - B-2 (EW)
HI
Below 1 Ω
Rear Washer Switch (w/o Rain Sensor, for RHD Windshield Wiper Switch LH Side Type) 
Resistance
A-10 (WR) - B-2 (EW)
Off
10 kΩ or higher
B-4 (+1R) - B-2 (EW)
A-10 (WR) - B-2 (EW)
WASH
Below 1 Ω
A-10 (WR) - B-2 (EW)
On + WASH
Below 1 Ω
B-4 (+1R) - B-2 (EW)
Headlight Cleaner Switch Assembly 
Resistance
5 (E) - 8 (B)
Headlight cleaner switch on
Below 1 Ω
B-4 (+1R) - B-2 (EW)
Headlight cleaner switch off
10 kΩ or higher
RELAY (w/ Headlight Cleaner System) 
Resistance
6 (PB) - 4 (E)
Battery voltage not applied
10 kΩ or higher
Battery positive (+) → Terminal 3 (IG)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)
Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 2 (H)
Battery negative (-) → Terminal 4 (E)
Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount
Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 1 (HDLO)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)
RELAY (w/ Rear Wiper) 
Resistance
3 - 5
Battery voltage not applied between terminals 1 and 2
10 kΩ or higher
Battery voltage applied to terminals 1 and 2
Below 1 Ω
← TORQUE SPECIFICATIONS (from Aug 2013)TORQUE SPECIFICATIONS (from Aug 2013) →