2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


REMOVE AIR CONDITIONING CONTROL ASSEMBLY
  1. Disconnect the air conditioning control assembly connector.

  1. E204872E05
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (IG) - 8 (E)
    Engine switch off
    Below 1 V
    1 (IG) - 8 (E)
    Engine switch on (IG)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    8 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Air Conditioning Control Assembly)
    If the result is not as specified, repair or replace the wire harness or connector.

  1. Connect the air conditioning control assembly connector.

  1. B250502E01
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    13 (RLY) - 8 (E)
    Engine running, seat heater switch LH on
    9 to 12 V
    4 (COM) - 8 (E)
    11 to 13 V
    12 (RLY) - 8 (E)
    Engine running, seat heater switch RH on
    9 to 12 V
    3 (COM) - 8 (E)
    11 to 13 V

    Text in Illustration 
    *a
    Component with harness connected
    (Air Conditioning Control Assembly)
    If the result is not as specified, replace the air conditioning control assembly.

← COMPONENTS (from Aug 2013)REMOVAL (Aug 2013 – Jul 2014) →