2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL AIR FUEL RATIO SENSOR

A239605E01
  1. Using SST, install the air fuel ratio sensor to the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    Text in Illustration 
    *1
    Fulcrum Length

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.

  1. A239606E01
    Connect the air fuel ratio sensor connector and attach the clamp.
    Text in Illustration 
    *1
    Wire Harness
    *2
    Clamp

    HINT:
    Make sure that the part of the wire harness labeled A is as shown in the illustration.

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →