2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT WHEEL LH

3. REMOVE FRONT FENDER MUDGUARD LH

B236298
  1. Remove the 2 clips and 4 screws.

  1. Remove the front fender mudguard.


4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

A246618E01
  1. Remove the 2 screws and bolt from the front fender splash shield sub-assembly.

    Text in Illustration 
    *1
    Bolt
    *2
    Screw

  1. A246619
    Remove the 12 grommets and front fender splash shield sub-assembly.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.


5. REMOVE GLOW PLUG CONTROLLER

A246625
  1. Disconnect the 4 connectors and clamp.

  1. Remove the 2 nuts and glow plug controller from the vehicle.


6. REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET
  1. Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.


7. REMOVE NO. 2 GLOW PLUG CONTROLLER BRACKET
  1. Remove the 2 screws and No. 2 glow plug controller bracket from the glow plug controller.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →